printer.cfg modified - 28.10.2025 - 00:07:18

printer_data/config/printer.cfg

@@ -40,6 +40,12 @@ enable_force_move: true
 serial: /dev/serial/by-id/usb-Klipper_stm32f407xx_2B0024001150304235343520-if00
 restart_method: command
 ##--------------------------------------------------------------------
+
+[mcu scanner]
+
+canbus_uuid: fa54c42a161b
+
+
 [scanner]
 mcu: scanner            
 #   Offsets are measured from the centre of your coil, to the tip of your nozzle 
@@ -48,6 +54,22 @@ x_offset: 0
 #    adjust for your cartographers offset from nozzle to middle of coil
 y_offset: 25                        
 #    adjust for your cartographers offset from nozzle to middle of coil
+
+[adxl345]
+cs_pin: scanner:PA3
+spi_bus: spi1
+
+[resonance_tester]
+accel_chip: adxl345
+probe_points:
+    125, 125, 20
+
+[temperature_sensor Cartographer_MCU]
+sensor_type: temperature_mcu
+sensor_mcu: scanner
+min_temp: 0
+max_temp: 105
+
 [printer]
 kinematics: corexy
 max_velocity: 750